High Plains Harvesting, LLC v. Deere & Company d/b/a John Deere, No. 2:2023cv00191 - Document 17 (N.D. Tex. 2024)
Court Description: Memorandum Opinion and Order denying 5 Motion to Dismiss filed by Deere & Company. (Ordered by Judge Matthew J. Kacsmaryk on 2/20/2024) (cmk)
Download PDF
<![CDATA[
High Plains Harvesting, LLC v. Deere & Company d/b/a John Deere Doc. 17 N THE LINITED STATES DISTRICT COURT FOR THE NORTHERN DISTRICT OF TEXAS AMARILLO DIVISION HIGH PLANS HARVESTNG, LLC Plaintiff, 2:23-CV- 191-Z-BQ V DEERE DEERE & COMPANY D IBI A JOHN Defendant. MEMORANDUM OPINION AND ORDER Before the Court is Defendant's Motion to Dismiss under Federal Rule of Civil Procedure l2(bx6) ("Motion") (ECF No. 5). For the reasons explained infra,it is DENIED. Blcxcnouxu A 2018 John Deere Cotton Stripper, Model CS-690 ("Cotton Stripper"), ignited while Plaintiff s employee was routinely harvesting cotton. ECF No. l-3 at 2. Plaintifl's investigation determined that the fire "began in the 'accumulator' and rapidly spread to other areas, leaving the operator unable to extinguish the fire in a timely manner to avoid . . . substantial damage." Id. Defendant knew of the design defect, per Plaintiff and could have installed a fire suppression system. /d It did not. Lnc.lr. SuxolRo "To suryive a motion to dismiss, a complaint must contain sufficient factual matter, accepted as true, to 'state a claim to relief that is plausible on its face."' Ashcroft v. Iqbal,556 U.S. 662, 678 (quoting Bell Atl. Corp. v. Twombly, 550 U.S. 544, 570 (2007)). "[T]he well-pleaded Dockets.Justia.com allegations of a complaint must be taken as true and viewed in the light most favorable to the plaintiff." George v. SI Group, Inc.,36 F.4th 611, 619 (5th Cir. 2022). Ax.l,r,vsrs Plaintiff alleges the tbllowing claims: and (a) breach of warranties. ECF No. (l) design defect; (2) failure to wam; (3) negligence; l0 at7-9. Because Plaintiff did not assert a manufacturing defect claim, the Court need not consider Defendant's motion to dismiss it. See ECF Nos. 5 at 3- 4 (requesting that the Court dismiss a manufacturing defect claim); l0 at 8 (Plaintiff disavowing manufacturing defect c laim). I. Plaintiff asserts a plausible design defect claim. To state a plausible design defect claim, "a plaintiff must allege how (1) the product was defectively designed so as to render it unreasonably dangerous; (2) a safer alternative design existed; and (3) the defect was a producing cause of the injury for which the plaintiff seeks recovery." Garcia v. Deere & Co., No. 3:20-cv-095, 2021WL 3745188, at *l (S.D. Tex. March 23,2021) (internal marks omitted); Timpte Indus., Inc. v. Gish,286 S.W.3d 306,31I (Tex. 2009). Defendant argues that Plaintiff inadequately pled a safer alternative design. ECF No. 5 at 2-3. "\n order to successfully plead the existence of a 'safer alternative design,' the design must be one that would have prevented or significantly reduced the risk of [damage] . . . without substantially impairing the product's utility." Carlton v. Olympus Corp. of Americas, l:18-CV- 00026-LY, 2019 WL 6037322, at t7 (W.D. Tex. July 26,2019), report and recommendation adopted,2Ol9 WL 6037277 (W.D.Tex. Aug. 23,2}lg)(internal marks omitted). Plaintiff s investigation concluded that a Cotton Stripper with an "effective fire suppression system" would have been safer. ECF No. 1-3 at2. Plaintiff further alleges that "using that design 2 would have been reasonable from a financial and technological standpoint . . . [and] would have kept most of the product's use and utility, while reducing the risk of injury." Id. at3. The foregoing constitutes an adequately pled safer alternative design, as the combustion and Plaintiff s post-accident investigation clariff that a safer alternative would have included an automatic fire suppression system. Id. at 2. Defendant objects that Plaintiff "does not adequately describe its alternative design or allege how it was safer" - perhaps not to Def'endant's liking, but enough to satisfr Plaintiffs pleading requirements. Further, Defendant's reliance on Carlton is inapposite. See ECF No. 5 at 2. There, plaintiffs alleged six altemative designs that were not measurably safer. Carlton, 2019 WL 6037322, at *8. But a tire suppression system targeting spontaneous combustions demonstrates that is not the case here. Defendant's proposed caselaw, for good measure, emphasizes the adequacy of Plaintiffs proposed safer altemative design.InGarcia,for example, there was no eyewitness to the allegedly defective tractor. Garcia, 2021 WL 3745188, at * l. It is thus unsurprising that these plaintiffs "fail[ed] to identifu any specific alternative design, much less describe how that alternative design was safer . . . ." Id. at *2. Not so here, where Plaintiff alleges eyewitnesses to the spontaneous combustion and further alleges Defendant's prior knowledge. And there is no question at this stage that a fire suppression system would have made the combusting Cotton Stripper safer. II. Plaintif?s failure-to-warn claim is plausible. To state a plausible failure-to-warn claim, Plaintiff must plead facts showing: (l) a risk of harm inherent in the product or that may arise from its intended or reasonably anticipated use; (2) the manufacturer actually knew or should have reasonably foreseen the risk of harm when the product was marketed; (3) the product contains a marketing def'ect; (4) the absence of a warning ^J renders the product unreasonably dangerous; and (5) failing to warn caused the user's injwy. Id. Defendant argues that Plaintiff inadequately demonstrated that dangers would occur without the fire suppression system; that Plaintiff failed to allege the Cotton Stripper was "unreasonably dangerous"; and that Plaintiff failed to articulate an adequate warning that would have prevented the harm. ECF No. 5 at 5-6. Plaintiffalleges that Defendant "was aware of the dangers associated with the same model of cotton stripper due to many being involved in and destroyed in previous flres," and in 2018 it "t-ailed to design and install an effective fire suppression system in the newer manufactured models, and the subject model in question." ECF No. 1-3 at 2. Defendant further "failed to warn [Plaintitfl of the dangers inherent in the Cotton Stripper in question when sold without an incorporated automatic fire suppression system . . . ." Id. at 4. The foregoing sufficiently addresses Defendant's objections. First, Defendant's knowledge of previous combustion incidents demonstrates a plausible case of future dangers without a fire suppression system. Second, Plaintiff stated in readily perceptible terms how Defendant's alleged failure to warn would have made the Cotton Stripper unreasonably dangerous. Defendant, per Plaintiff, sold a spontaneously combusting Cotton Stripper and did not warn Plaintiff; the unreasonable danger here is apparent. Third, even if Plaintiff needed to "articulate warning that would have prevented the harm," Carlton,2019 WL 6037322, at authoritv suggests it must - an adequate *ll, - and no Defendant's obvious alternative was to warn consumers about the combustion problem. ECF No. 1-3 at 4. It did not, and this accident resulted. 4 III. Plaintif?s negligence and breach-of-warranties claims survive. Defendant argues that Plaintiffs negligence and breach-of-warranty claims should be dismissed "for all the reasons [its] strict liability claims should be dismissed . . . ." ECF No. 5 at 6. Thus, based on the analysis supro, these claims may also proceed. Coxclusrox Defendant's Motion is DENIED. SO ORDERED. Febru ary f, ,2024 MA J. KACSMARYK UNITED STATES DISTRICT JUDGE 5
]]>
Some case metadata and case summaries were written with the help of AI, which can produce inaccuracies. You
should read the full case before relying on it for legal research purposes.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
